BrockMoto

well?

What he said Sent from my 0PJA2 using Tapatalk

Renthal has factory bend banshee bars on closeout. $40

Easy enough, will do. By the looks of his barn, there will be lol

I bought a friend's banshee i know it has atleast sat in his shop for 3 years could have been longer. It is my second so i'm not totally clueless just wondering where to start on a bike that has sat so long. Anything i need to watch out for? Was planning to do a leak down and compression check, clean carbs and chain and i have some random tires laying around... anything else? He rode it in the garage and parked it, had a kid and 3 years later its mine

did l miss a price on the shifter?

yes, assuming the idling and "air sucking" is a new problem (post bowl removal) sounds like when you reinstalled you missed the choke tube.... That fuel leak should be a simple fix... and as motooutcast said... service manual FTW

Sounds like your float stuck a little... Tap it with the butt of a screwdriver should fix it, if it keeps happening clean your carbs real good and shut the gas off when you put it up

Everything in this list, ^ he can do for you

Yes the slot in the back of the gear could be worn.... If your impeller is discolored that means its still plastic lol and you should get a billet impeller. How do the fins look on your radiator? And when you checked the plugs was that a fresh set ran and chopped or did you just check the ones you had in it? Something may have changed

^^^ This

Hard to go wrong with either, but Mull has a billet gear too... which is nice

Fuel, spark, compression, need all three to work, check all three and eliminate them... And as far as top end goes its very simple, but I'd recommend sending your cylinders to a site sponsor to be bored, might as well be ported too, then get a rebuild kit (from the same builder) and install... Then do a leakdown, compression test, rejet and zoom